Brccee AC FR PVC Cover Flame Retardant Sleeve for ANDERSON Powerpole Connector Housing (10PCS)

These little rubber boots, fit my Anderson Power Pole Connectors just fine, and work great. You can even add a short piece of heat shrink tubing, to add even more protection, and stability! But these work fine on their own! I will purchase these again.

I debated for a while about these, my only hesitation was the comments of extended delivery times. So when I finally decided to order, I ordered two packages. Received them this morning and just finished a fuse link setup with them. WISH I'd ordered four packs!!!Although though they only offer a small amount of stress relief, they do give some and offer a lot of dust/dirt protection on the back side and just give the cables a very nice "finished off" appearance. Not to mention, they cover the sea coral sharp edges of my PowerPole edges and corners.My first application was on 12awg zip cord so I just barely trimmed a bit from the closed end and ended up with a very nice snug fit. I don't foresee a problem with 10ga but larger may be mighty tight. I think if I ever have the desire to use these on anything smaller than say 14awg, I think I'll use a leather hole punch to cut a nice small hole and using a round wood dowel that fits up inside the boot as the anvil for the punch.As far as the shipping goes, I received mine within a week and during the C O V I D - nineteen crisis.I would definitely (probably on my next Amazon order) order again and could recommend without hesitation.

For what they are they work alright. I thought these were hear-shrink to really give it a nice tight finished look. They are not. As for a cover it fits a little loose but better than nothing.

This is my second time purchasing these boot covers for Anderson Pole connectors. I went back and added them to all my cables and connections that I have made in the past. There is no hole on the end, so you have to make your own. I usually drill a hole through the end, using a drill bit that is just a bit under the size of diameter of the wire that I intend to use. If the drilled hole is a bit to small when I try to poke the wire through it, I carefully cleanup the hole using very pointy wire cutters until the opening is large enough to allow the wires to go through it. Patience at this point will result in a very nice, clean looking installation once the boot cover is in place. The first time that I ordered these it seemed like it took forever, but with this last order they came the following day. So I am that much happier.

These work well with my ANDERSON Powerpole Connectors.

These give a nice finished look for the anderson connector pigtails. You can't beat the cost of these.

Bought these to cover a pair of Anderson PowerPole 15/45 connectors. The fit nicely over the connectors and provide a good gripping surface when connecting or disconnecting the units. This is especially helpful when you are out in a rainstorm and trying to make the connections in the dark. The end where the wire runs through requires you to make an opening but that lets you customize the fit to your needs. Good value also.

Didn’t know the device I was buying them for came with them too. But I can use them for other projects so I’m happy .