Tecusmeh Carburetor Gas Line Inlet Plastic Elbow Fitting 640363 - 2 Pack

but I`ll keep them for the next job

Arrived quickly. As advertised. Ice auger finally works. Now....just need ice on the lake!

O. E. M. part. - HARD TO SNAP ON! I set the part on and tried to gently tap on with hammer and wood dowel. The second one I warmed up with a heat gun I use for paint stripping (hair dryer should work but part will need to be held closer to nozzle) and it snapped right on with a little finger pressure. I used needle nose pliars to hold the part about10-12" from the heat gun nozzle. Be careful to not get the plastic part too hot (rotate frequently when heating) as it will melt and deform. Check part often when heating.. it should be very warm to the touch for best results. Good luck and hope this helps!

This fitting along with the fuel line tubing was a good replacement for the small displacement motor it was purchased for. It was an exact match for the one that came with the motor. It fit the tubing exactly and doesn't leak. It seems to be of decent quality and if all you need is one you will have a spare just in case.

Tapped it on with a wide center punch, worked like a charm

works great

it fit.

Can't get past the fact that they are plastic. Also was to small for my eskimo ice auger